Technical & Reference Section > Tech and Restoration

nitro mors problems !!!

(1/3) > >>

oldschoolrb:
i'v use it befor with no problems at all , but its not doing what it says on the tin ! :tickedoff: anyone any ideas i'm ready apply it with a lump hammer ............... >:(

sid1972:
what are you putting it on?  ???

meticulous:
i've had the same problems with the stuff, i think they thin it down at the factory hoping no one notices...

Voodoocars:
shake the tin thoroughly then apply and cover with cling film or a plastic bag to keep the air out and it will work.

oldschoolrb:
it is a new tin ! the last stuff worked fine . i'm stripping a frame that was chrome befor someone sprayed it, it gets through some parts of the top coat and its hardly touching the under coat . i'v scrached though it and it defo chrome underneath it so how could it key in so well  ??? ill give it a go covering it see how that goes tomorrow

cheers

Navigation

[0] Message Index

[#] Next page