RADBMX.CO.UK

Old School BMX 1980 - 1988 => Old School Race (riders ready, pedals ready... GO!!) => Topic started by: james1973 on November 29, 2006, 08:22 PM

Title: PK Ripper gear question
Post by: james1973 on November 29, 2006, 08:22 PM

Im going to build my ripper up as a race bike, not to use, just to look at, was thinking of putting a gold tuff neck power gear on her, would this be technically correct for a racer? and what freewheel should I go for on the back?

Title: Re: PK Ripper gear question
Post by: harris on November 29, 2006, 08:25 PM

44 /16 rear as an average but just to look at ,then put on what you like mate.

Title: Re: PK Ripper gear question
Post by: james1973 on November 29, 2006, 08:28 PM

Cheers thanks mate, just wanted to get it right so I dont get shot to pieces when I post the finished article up!!!!  :LolLolLolLol:

Title: Re: PK Ripper gear question
Post by: harris on November 29, 2006, 08:30 PM

 :police:

Title: Re: PK Ripper gear question
Post by: Mattdub on November 30, 2006, 12:36 AM

42/16
43/16
44/16

Any of above bitd  :daumenhoch:

Title: Re: PK Ripper gear question
Post by: theRuler on November 30, 2006, 05:11 AM

build it how you like mate!!

there aint no rules when it comes to bike building!!

post a pic when it's done