RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: wfbmx on February 05, 2010, 05:59 PM
-
Im after some advice on how to strip a powered coated black loop tail ripper frame and return it to its original baby blue colour.
Im after a professional finish and based in west midlands if this helps.
Im new to rad so be nice!
cheers!
-
send it down to the sbd, hes the bollox.
:daumenhoch:
look in the tech section for him
-
superbike dan on here mate he is spot on
-
Im after some advice on how to strip a powered coated black loop tail ripper frame and return it to its original baby blue colour.
Im after a professional finish and based in west midlands if this helps.
Im new to rad so be nice!
cheers!
im in the midlands too mate and i would send it to sbd for sure :daumenhoch:
-
super bike dan ,,,without a doubt ,,,,he will do the stripping :buck2: and his finish is the bollox :smitten:
-
SBD for sure 8)
(http://www.radbmx.co.uk/archive/albums/b366/claire169/Master86005.jpg)
-
SBD is the nuts.....he did my Hoffman :daumenhoch: :daumenhoch: :daumenhoch:
give him a call he's really helpfull...top bloke
-
You can also try FHMReader on Burnerworld he runs a powdercoating company and his work is flawless as well. Not too pricey either. He's based in Darlington.
There's also Buttsbikeshop, he's also on Burnerworld and he comes highly recomended from everyone that's used him. He does chroming, zinc work as well. Almsot a one stop shop.
SBD is also very good, he's done a few of my frames with no problems at all. :daumenhoch:
-
thxs everyone. Great advice!