RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Gish on March 06, 2010, 11:07 AM
-
just put some pedal cages in oven pride. just wondering do i leave them in the bag for 2 hours like it says and will it damage them if i leave them in longer :)
-
dont leave em 10 mins if they are alloy mate. if they are steel they should be okay
-
Just long enough to make a brew :daumenhoch:
If you rub the cages in the bag you will see the anno coming off (should only take a few minutes). Don't forget to give them a good rinse in clean water afterwards.
-
oven pride may not do them dude as i think they are painted so nitromorse wouls do the trick, if using oven pride check them every 5 mins by rubbing through the bag as if ya leave em too long it will discolour the top layer of ali and take ya twice as long to polish up , i also tend to use an old tooth brush to remove any stubborn bits :daumenhoch:
-
::) yep what he said. i tried a set of black suntours the other week and it removed some but left loads of black on so i would say defo painted and not anno if they are black.
-
well guys the oven pride didnt work ??? so here i go with the nitromors :D
-
not even nitromors is removing the paint :wtf:
-
What cages are they ???
-
Could they be powdered or an enamel type finish ???
Any pics :-\
-
sounds to me like they are powdered :-\
-
i had to use wire wool to rub them down fluckin nightmare ???