RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: Stella Dave on June 02, 2010, 08:58 PM

Title: Ody Driver fitting
Post by: Stella Dave on June 02, 2010, 08:58 PM

Took my Ody 10t driver off to remove the grease I'd put in as it was sticking a wee bit.

When putting it back in and the nut on hand tight the driver is very stiff! As soon as it tightens it goes against the rubber seals and gets stiff.

Cant see any other way to put it in but I dont rem it being that stiff before.

Any fitting guides please??

Title: Re: Ody Driver fitting
Post by: Gary72 on June 02, 2010, 09:47 PM

Is there a collar that you have left out?
Goes between the bearings in the hub and the bearings in the driver.

Title: Re: Ody Driver fitting
Post by: Bettyswallocks on June 02, 2010, 10:00 PM

What hub is it dude?

Odyssey have some instructions online

http://www.odysseybmx.com/techcorner/

Title: Re: Ody Driver fitting
Post by: Stella Dave on June 02, 2010, 10:38 PM

It's a 1 piece for use with Hazard Cassette.

The axle has a step in it so it only goes in so far. I think I have to get the distance just right with the seal using the opposite axle nut??