RADBMX.CO.UK

Old School BMX 1980 - 1988 => Old School Race (riders ready, pedals ready... GO!!) => Topic started by: FuNMoNsTeR on April 23, 2006, 07:09 PM

Title: Vector Mark II rear tri probs
Post by: FuNMoNsTeR on April 23, 2006, 07:09 PM

Sorry for posting this here... i am hoping one of you older guys used to ride a Vector.
  Ok... I have an old school shimano hub and a suzue hub... both standard bmx spacing(110mm). The spacing on the rear triancle of the Vector Mark II is 95mm inside to inside. I dont want to spread the rear tri and force a wheel in. If i take off both cone nuts each side it fits but the sprocket is then still hard up against the inside of the stay.... Does anyone have any clue what kind of Hub i will need to fit this bizarre spacing?

Title: Re: Vector Mark II rear tri probs
Post by: Bob_Acid on April 23, 2006, 10:51 PM

bend it, that's how i always did it on frames with the same problem

Title: Re: Vector Mark II rear tri probs
Post by: darren on April 24, 2006, 08:29 AM

pm mattdub he has a vector too he may be able to help.