RADBMX.CO.UK

BMX General => BMX Chat => Topic started by: HARORIDER on May 17, 2011, 04:19 PM

Title: FITTING SKYWAYS TO A BMX WITH 14MM DROPOUTS
Post by: HARORIDER on May 17, 2011, 04:19 PM

as skyways have 10mm axles would it be ok to just put them in and tighten up or use a 10-14 axle convertor? trouble is i've only seen threaded versions which do not fit the skyway thread-anyone done this already? what did you do?

Paul  :daumenhoch:

Title: Re: FITTING SKYWAYS TO A BMX WITH 14MM DROPOUTS
Post by: Jaymz on May 17, 2011, 04:37 PM

get the little washers that convert 10mm to 14mm, cheap enough

Title: Re: FITTING SKYWAYS TO A BMX WITH 14MM DROPOUTS
Post by: HARORIDER on May 17, 2011, 04:48 PM

Quote from: Jaymz on May 17, 2011, 04:37 PM

get the little washers that convert 10mm to 14mm, cheap enough

where from :-\  :daumenhoch:

Title: Re: FITTING SKYWAYS TO A BMX WITH 14MM DROPOUTS
Post by: kuwahero on May 17, 2011, 04:54 PM

http://www.alansbmx.com/product_info.php?cPath=32_44&products_id=3567 (http://www.alansbmx.com/product_info.php?cPath=32_44&products_id=3567)

Title: Re: FITTING SKYWAYS TO A BMX WITH 14MM DROPOUTS
Post by: Jaymz on May 17, 2011, 04:56 PM

Quote from: kuwahero on May 17, 2011, 04:54 PM

http://www.alansbmx.com/product_info.php?cPath=32_44&products_id=3567 (http://www.alansbmx.com/product_info.php?cPath=32_44&products_id=3567)

:daumenhoch:

Title: Re: FITTING SKYWAYS TO A BMX WITH 14MM DROPOUTS
Post by: HARORIDER on May 17, 2011, 09:35 PM

cheers guys  :daumenhoch:

Title: Re: FITTING SKYWAYS TO A BMX WITH 14MM DROPOUTS
Post by: spesh on May 18, 2011, 08:33 PM

i have a full set of front and rear axle converters (threaded) specifically for skyways 36/24 tpi
i had them on my haro zippo after using washers but they kept slipping in the drop outs so i bought the converters
as it was a rider
pm me if your interested :daumenhoch: