RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: p1nell on May 30, 2011, 01:22 PM

Title: vector vc8 and vc10 help
Post by: p1nell on May 30, 2011, 01:22 PM

Hi, just wondering if anyone can shine some light on the widths these bars came in if possible??

I've seen the old advert pics that say 28" and 30", just wondered if they did a vc8 26"?

Title: Re: vector vc8 and vc10 help
Post by: MartyC on May 30, 2011, 01:36 PM

Quote from: p1nell on May 30, 2011, 01:22 PM

Hi, just wondering if anyone can shine some light on the widths these bars came in if possible??

I've seen the old advert pics that say 28" and 30", just wondered if they did a vc8 26"?

I've never seen a pair at 26" however that's not to say someone has not trimmed a pair down.  I'd need to measure my VC10's but I am sure they are only 28" wide  :-\.

Title: Re: vector vc8 and vc10 help
Post by: MartyC on May 31, 2011, 01:51 PM

Good stuff, maybe they did make them narrower.  I'll have a check tomorrow and see what mine measure  :daumenhoch:.

Title: Re: vector vc8 and vc10 help
Post by: animal on May 31, 2011, 07:53 PM

I'm sure mine were 28 inches wide  ::)

Title: Re: vector vc8 and vc10 help
Post by: MartyC on June 01, 2011, 12:54 PM

Quote from: ANIMAL on May 31, 2011, 07:53 PM

I'm sure mine were 28 inches wide  ::)

Just measured mine, they are just over 28 1/4 inches so take a little off for the grips and I reckon 28 inches  :daumenhoch: