RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: crazycraig on September 09, 2011, 09:18 AM

Title: Tuf neck /Pro neck Shaft Extraction
Post by: crazycraig on September 09, 2011, 09:18 AM

How the fook do these things come out ? Are they threaded ?

Title: Re: Tuf neck /Pro neck Shaft Extraction
Post by: hazzajoe on September 09, 2011, 09:29 AM

not sure if all them are, but mine is.

I clamped the stem using soft jaws in a large bench vice and using a socket and power bar . I cracked it off the normal way. Anti-clockwise. around the large bolt head I used electrical tape to protect the face of the stem from the socket.

I'm sure people have better ways.  :daumenhoch:

Title: Re: Tuf neck /Pro neck Shaft Extraction
Post by: crazycraig on September 09, 2011, 09:31 AM

Are you talking about the shaft or the large nut hazza ?

Title: Re: Tuf neck /Pro neck Shaft Extraction
Post by: crazycraig on September 09, 2011, 11:37 AM

So they are not threaded ? This threads for you Snav !!!! 3 into 1 does go 

Title: Re: Tuf neck /Pro neck Shaft Extraction
Post by: meticulous on September 09, 2011, 01:20 PM

craig, heat up the alloy with heat gun/paint stripper gun, and get the alloy red hot, it will expand enough to allow just a light tap with a lump hammer on top of the big nut, better still send it to CCA, they do it all for you if your having it re-anoed...

Title: Re: Tuf neck /Pro neck Shaft Extraction
Post by: crazycraig on September 09, 2011, 06:58 PM

Cheers chaps  :daumenhoch: