RADBMX.CO.UK

BMX General => BMX Chat => Topic started by: GT world on September 09, 2011, 09:49 PM

Title: A few bars to ID...updated images
Post by: GT world on September 09, 2011, 09:49 PM

Hi all,
As im coming to the end of some of my builds i need to confirm a few of my parts i have.
 Firstly is a few bars:

Ive had a few remarks regarding the top ones..2 parties claimed these are starbars..very tight welds and a shiny area on the front left side where a small decal would have been.

Then we have what i was told were curtis bars...again i welcome your thoughts

The bottom ones are defo reynolds as the decal is still sort of visible but im wondering what these are all about?

I can measure or take extra pics if it helps

Cheers in advance Neil  :daumenhoch:
(http://www.radbmx.co.uk/archive/albums/jj243/gtworld/DSCF0485.jpg)

Here is a few new pics to hopefully help  :daumenhoch:

(http://www.radbmx.co.uk/archive/albums/jj243/gtworld/DSCF0514.jpg)

Reynolds weld and whats left of the decal...these measure 26" wide...11 and a half on the cross bar
(http://www.radbmx.co.uk/archive/albums/jj243/gtworld/reynolds.jpg)

Maybe starbar's... welds...these are light as hell by the way and the welds are tiny and tight.
Also check the lefthand side just under the weld...it seems shiney as if a small decal once was?
These are 28" wide and cross bar again 11.5"

(http://www.radbmx.co.uk/archive/albums/jj243/gtworld/starbarmaybe.jpg)

Finally the bars i was told were curtis for your viewing...these seem quite heavy and look to have a long shiny area on the front left.These are 29" wide and cross bar is 11"

(http://www.radbmx.co.uk/archive/albums/jj243/gtworld/curtismaybe2.jpg)

(http://www.radbmx.co.uk/archive/albums/jj243/gtworld/curtismaybe.jpg)

Title: Re: A few bars to ID
Post by: animal on September 09, 2011, 09:57 PM

BTm r MRD expert bars  ;)

Title: Re: A few bars to ID
Post by: animal on September 09, 2011, 09:59 PM

Middle bars r Identical 2 a set of Bars Cupid Stunt Si had  ;) they r brit made but we have no idea where as yet  ::)

Title: Re: A few bars to ID
Post by: stevochb on September 09, 2011, 10:01 PM

Hi Neil, get your tape measure out mate so we can get an idea of the sizes and get some closer pics of welds  mate some one will know what they are :daumenhoch:

Title: Re: A few bars to ID
Post by: GT world on September 09, 2011, 10:10 PM

Ill do that in the morning steve as its a loft job....wine and ladders aint good  :LolLolLolLol:

Title: Re: A few bars to ID..
Post by: GT world on September 10, 2011, 02:35 PM

Updated pics and sizes....Hope this helps  ;)

Title: Re: A few bars to ID...updated images
Post by: GT world on September 29, 2011, 10:06 PM

Any idea's ....Bump ?  :-\

Title: Re: A few bars to ID...updated images
Post by: GT world on October 06, 2011, 07:57 PM

Do i smell  :LolLolLolLol: