RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: dordymush on October 08, 2011, 12:34 AM
-
got a set off 400 flite for my patterson but am having probs with bearings as it never came with any.
got 22mm but there a mile to big.
bought a 19mm set off bof and they wont fit the shaft either.
any idea what they might be.
can you get 20mm to fit a usa bottom bracket.
-
You can get a 20mm bb, I had one on a mid school diamondback crank. I think billy's sell an unsealed 20mm bb.
-
Yep, you can get a 20mm bb for a USA shell Dave - I think Alan's had one? I'll have a look later bud.
-
you could try these from a member on here.
http://www.radbmx.co.uk/forum/index.php'topic=117557.0 (http://www.radbmx.co.uk/forum/index.php'topic=117557.0)
-
Dave measure the outside diameter of your 22mm bearings ( primo) , if it measures 42mm then you can push out those bearings and buy some 6004 bearings from a bearing factor
or http://www.winstanleysbmx.com/product/15490/ETC_20mm_Bottom_Bracket
-
ive got one of those sets from cuckoo and they are awesome,even the correct bearings!! dave if youre totally stuffed i have cups and bearings for the 400's which you can have for nout,they are black which is why i didnt use them but they do the job and came with a set of 400's i bought off a member here,lmk :daumenhoch:
-
Mark's right Dave
I bought the 400 kit spindle and bearings from Lee (Cuckoo) on Museum a couple of years ago
They are top notch and recommended him to a few people on here , all very impressed :daumenhoch: