RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: Mdbh on February 19, 2012, 01:09 PM

Title: ACS B.O.A???
Post by: Mdbh on February 19, 2012, 01:09 PM
hi guys,
is it possible to run a rear acs boa on the front? i know the cable adjusters will be the other way around but are these not just bolted on? or are they fixed in place?
Title: Re: ACS B.O.A???
Post by: brummie on February 19, 2012, 01:11 PM
if the spindle is long enough then yes. but it probably wont be tbh
Title: Re: ACS B.O.A???
Post by: Mdbh on February 19, 2012, 01:40 PM
Oh right that's y! It's not the cable set up then?
Title: Re: ACS B.O.A???
Post by: kev-s on February 19, 2012, 03:02 PM
rear axle is too short, 6mm boa's are rare, 10mm ones are around if u drill out your forks, failing that look at dia compe nippons as they were popular in 92
Title: Re: ACS B.O.A???
Post by: Tonto on February 19, 2012, 07:28 PM
I have front and rear the front have longer spindle that the rear and I just swaped cable route to feed from bottom on the front and top on the rear
Title: Re: ACS B.O.A???
Post by: BENDYCAT ELEVENTEEN on February 19, 2012, 09:10 PM
I got a front 10mm if needed
SimplePortal 2.3.5 © 2008-2012, SimplePortal