RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Jaan on September 12, 2012, 05:13 PM
-
I need a BB set up, preferably sealed to run a CT175 on a Haro Master, will this work/fit? ???
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=370622155507&ssPageName=ADME:X:RTQ:US:1123
Cheers
Chris :daumenhoch:
-
I've got one here and it looks to have the same dimensions. I ran it with a Takagi Ultra Dyno on a Laserlite (for the London to Brighton ride).
Not much room for adjustment left & right on them but it didn't let me down.
-
Cheers, think I'll post a wanted for 24 hours and order one response dependant.
-
No worries :daumenhoch:
Porkchop was selling them a while back but he seems to be out at the moment.
There should be plenty kicking around.
-
i just bought one to go on my KZ1, the axle fitted at the mo is wider than the measurement they give, but could do with spacing it in anyways. il let you know how it goes when it arrives (hopefully in time for sundays london ride)
on a different note, i just fitted one of these to my 'goose FS1 and its foookin silky smooth lushness :D
http://www.ebay.co.uk/itm/180939061731'ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#ht_1121wt_842
-
Mmmm that looks nice, let me know how you get on with your KZ1, are you fitting VX cranks? :smitten:
-
Got some VX'S and a set of sugino super Maxys too :daumenhoch: