RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: denzil on September 15, 2012, 12:51 PM

Title: Engraving Tuf-neck stem.
Post by: denzil on September 15, 2012, 12:51 PM

Im after a tuf-neck 2000 stem re-engraving , i talked to someone at MK and they told me someone on here can re do the engraving on stems. does anyone know who it is who does it? cheers  :daumenhoch:

Title: Re: Engraving Tuf-neck stem.
Post by: BENDYCAT ELEVENTEEN on September 15, 2012, 01:50 PM

Was it Shakey Dave ?

Title: Re: Engraving Tuf-neck stem.
Post by: markyp on September 15, 2012, 02:09 PM

Quote from: BENDYCAT ELEVENTEEN on September 15, 2012, 01:50 PM

Was it Shakey Dave ?

is that how the engraving turns out?? ;D

Title: Re: Engraving Tuf-neck stem.
Post by: denzil on September 15, 2012, 02:10 PM

Quote from: BENDYCAT ELEVENTEEN on September 15, 2012, 01:50 PM

Was it Shakey Dave ?

i dont know mate, cant remember.

Title: Re: Engraving Tuf-neck stem.
Post by: rad_pitt on September 15, 2012, 02:22 PM

Think Carl (in2bmx) did it with good results Denzil  :daumenhoch:

Title: Re: Engraving Tuf-neck stem.
Post by: denzil on September 15, 2012, 03:04 PM

Quote from: rad_pitt on September 15, 2012, 02:22 PM

Think Carl (in2bmx) did it with good results Denzil  :daumenhoch:

nice one Tom , i will send him a pm. :daumenhoch:

Title: Re: Engraving Tuf-neck stem.
Post by: In2 bmx on September 15, 2012, 03:09 PM

I've done a few now . But not had time to draw the Tuf neck artwork ..  :daumenhoch:

That might be a job for jaymz ... And I can engrave it  :daumenhoch:

Title: Re: Engraving Tuf-neck stem.
Post by: BENDYCAT ELEVENTEEN on September 15, 2012, 04:30 PM

what about Wobbley Pete  ???