RADBMX.CO.UK
Mid School BMX (>87) 1989 to 2003 (<05) => Mid School ( Keep the faith ) => Topic started by: deshstar on September 27, 2012, 05:14 PM
-
Can anyone recall some of the chains that were in use between about 93-97 other than KMC?
-
Izumi, KMC, Sachs
-
Izumi all the way :daumenhoch:
-
acs
-
That's great, cheers guys :daumenhoch:
-
I always used Izumi or D.I.D apart from the terrible Kink moped chain phase. :-[
-
iv'e got a nos KMC one here that would deffo pull a town down ;D.
weighs a ton.
-
im sure i had a standard chain around that time...cost tons of money to ::)
-
I just got one of these from moonster and it is awesome:
http://www.ebay.com/itm/180975680478'ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
-
Tank & Bog chains,wieghed a ton and you could grind on em >:D
-
D.I.D were tough, sedis were not.
-
Izumi, KMC, Sachs
love your answer Jon ;D
-
Standard bykes heat treated,
nothing else comes even close.
-
Izumi, KMC, Sachs
love your answer Jon ;D
:LolLolLolLol: Only just saw this now. Meant to say DID not KMC. :daumenhoch:
-
Standard bykes heat treated,
nothing else comes even close.
Except the Tank/Bog/moped chain which was cheaper and stronger :P
-
Standard bykes heat treated,
nothing else comes even close.
Except the Tank/Bog/moped chain which was cheaper and stronger and WAY heavier :P
moped chains were a really shit idea,
they look cool though....
-
Standard bykes heat treated,
nothing else comes even close.
Except the Tank/Bog/moped chain which was cheaper and stronger and WAY heavier :P
moped chains were a really shit idea,
they look cool though....
I used one for a couple of years - ground the sh1t out of it and it lasted (was a 4-Jeri KMC)- admittedly weighed a ton, but weight wasn't where it was at in 98/99. Also had to saw the fooker to get it to size - broke a link remover trying to shorten it.
-
Standard bykes heat treated,
nothing else comes even close.
Except the Tank/Bog/moped chain which was cheaper and stronger and WAY heavier :P
Broke mine too.Recently used a couple of these chains and had to use a hammer and punch to shorten them etc,took fookin ages!!!
moped chains were a really shit idea,
they look cool though....
I used one for a couple of years - ground the sh1t out of it and it lasted (was a 4-Jeri KMC)- admittedly weighed a ton, but weight wasn't where it was at in 98/99. Also had to saw the fooker to get it to size - broke a link remover trying to shorten it.
-
In fact - 'ere are:
(http://i1236.photobucket.com/albums/ff443/dannywhack/4JeriBogChain.jpg)
-
http://www.ebay.co.uk/itm/KMC-BMX-Chain-Single-Speed-Chain-Freestyle-Extra-Wide-415H-1-2-x-3-16-Black-/280991589781?
:daumenhoch: :daumenhoch: :daumenhoch:
-
Which from all listed would be suitable for a race bike?