RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: kurtallen46gp2009 on October 09, 2012, 09:14 PM
-
(http://i1116.photobucket.com/albums/k570/kurtallen46gp/Picture.jpg)
this is my cyclecraft Lite Pro which iam goin to restore .
can anyone give me any info about this bmx ?
the only info i have is on the rear dropouts it has L P stamped which stands for Lite PRO
but above the letters it has 3 numbers which are 192 , i dont kno what it means .
it has a european BB and a dura ace crank set .
and what year it is
regards
kurt
-
Are you sure the three letters are not "I92"? If so that would indicate that the frame was the 92nd one made in September (I) of that year. :daumenhoch:
-
thanks
the 3 numbers are 192
but below the numbers on the rear dropouts is L P
it looks like this 192
L P
any idea what year the frame and forks are
i think it is a 1985 model as i looked on ( goin to swear ... bmx museum )
they have pros and xl but no L P mite be a rare bmx
correct me if im wrong
regards
-
Is difficult to get a date for CC frames,machined bb's usually denote expert or mini frames ???
The letters could mean a special frame though,as they did a few customs and team frames ???
Get some measurements up :daumenhoch:
-
what measurements do u require
-
top tube is 19 and a half inches ....... headtube 3.9 inches ........
seat tube length to top of BB nearly 10 inches
top tube thickness 3 inches ......... bottom tube thickness 4.5 inches
rear seat stays [top] 14.5 inches ........... rear seat stays [bottom] 12.6 inches [these are tube lengths]
-
unusual decals for a cc too ? are these the rims you wanted the valve hole size for? if so don't do it get some presta tubes :daumenhoch:
-
the decals are not original thats how i got the CC
yes its me what asked about drilling the rims . i wont drill them [phew]
their ukai 20 x 1and 1/8 with raleigh record tyres :)
-
top tube is 19 and a half inches ....... headtube 3.9 inches ........
seat tube length to top of BB nearly 10 inches
top tube thickness 3 inches ......... bottom tube thickness 4.5 inches
rear seat stays [top] 14.5 inches ........... rear seat stays [bottom] 12.6 inches [these are tube lengths]
Could be an expert size frame,judging by those measurements,and the angle of the seat tube,was the tt measured centre to centre ???
Whats the down tube length cr of bb to cr of headtube ???
May be able to measure one of the frames i have to compare :daumenhoch:
-
the top tube was measured centre to centre
bottom tube cr to cr is 19inches :)
-
Just had a look on the museum,there's 2 lp frames,or lite pros,87 and 88,looks like thats what you have :daumenhoch:
-
WOW!!!!! only 2 ..... must be a rare bmx, worth taking my time building it to a high standard
thanks for your help and info
mite be worth jmc money when finished lol