RADBMX.CO.UK
		Technical & Reference Section => Tech and Restoration => Topic started by: thecaptain on December 28, 2012, 01:34 PM
		
			
			- 
				A few weeks ago I asked if clear red grips (jive ez) could be dyed black, no one was sure and a few said that it wouldnt work, well I tried it today and it worked
 
 1.new jive ez grips
 
 (http://www.radbmx.co.uk/archive/albums/h272/southcoastbmx/eBay/frii003.jpg)
 
 2. boiled in a pot for 10mins
 
 3. removed let cool for 30seconds
 
 4. boiled enough water to cover grips, added about 4 tablespoons of salt and the whole pack of rit nylon dye
 
 5. put the grips in and let simmer on lowest heat for about an hour and a half
 
 6. took grips out carefully and put into a pot of cold water, took out and here they are!
 
 (http://www.radbmx.co.uk/archive/albums/h272/southcoastbmx/eBay/frii005.jpg)
 still a little wet from the cold water but have now dried off and are mint!
 
 hope this helps others
- 
				nice one tom.
 i got a couple of sets of these too.
 now wheres me boiling pot  :)
- 
				Well done Cap ~ top job  :daumenhoch:
			
- 
				Good work  :daumenhoch: ....Nice one!
			
- 
				Nice one, I gave away a mint set of black news before I realised they'd become rocking horse shlt
			
- 
				nice, did it soften them any as mine feel like hard plastic.
			
- 
				cheers guys! I think the pre-boiling definately helped, and they've become softer so much nicer for riding, win win!
			
- 
				Cool, just what I needed :daumenhoch:
			
- 
				Cracking job there tom, great result   :daumenhoch: