RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Funkyworm on April 04, 2013, 05:17 PM
-
Any ideas how to do this ?
Ive taken off the top bolt & spring cover , does the rest just unscrew ???? Never had one of these & I don't want to be heavy handed & break it as it'll be up for sale..
Cheers
-
You need to take the spring out then the rest will unscrew as normal :daumenhoch:
-
x2....... just ping it out of it's recess with a little flat screw driver, get rough with it!!! :daumenhoch:
-
All sorted, I looked a bit closer to realise that it just pinged out...
Thanks again !
-
x2....... just ping it out of it's recess with a little flat screw driver, get rough with it!!! :daumenhoch:
Shut it Hippie, I answered first! :-*
-
dib dobs if it a freestyle version ::)
-
x2....... just ping it out of it's recess with a little flat screw driver, get rough with it!!! :daumenhoch:
Shut it Hippie, I answered first! :-*
Your answer was just too vague!!! :Aresehole:
So is there rocket science involved re fitting?? Should there be a correct tension? Never had any problems with them but I just slide it down in the fork recess, twirl the fooker round and slot the other end wherever it'll go! Ingenious idea! :)
-
x2....... just ping it out of it's recess with a little flat screw driver, get rough with it!!! :daumenhoch:
Shut it Hippie, I answered first! :-*
Your answer was just too vague!!! :Aresehole:
So is there rocket science involved re fitting?? Should there be a correct tension? Never had any problems with them but I just slide it down in the fork recess, twirl the fooker round and slot the other end wherever it'll go! Ingenious idea! :)
Oh dear!
:-X
-
Again, not much of an answer!!!!!! :LolLolLolLol: