RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: Jim on September 11, 2013, 06:17 PM

Title: fork crown race not snug
Post by: Jim on September 11, 2013, 06:17 PM

ok so I replaced my copy landing gear with some stamped landing gear. the fork crown popped off the old forks with a wee bit of force but when I put it on the new forks its not a snug fit. I slipped the bearings on and rebuilt and it seems fine no wobbles? anyone has a similar issue or advice it would be gratefully received..... "help"

Title: Re: fork crown race not snug
Post by: Sid1972 on September 11, 2013, 06:25 PM

Often happens. Cut down a coke can and wrap a couple of centimeters round the base of the forks and tap the crown back on.

Title: Re: fork crown race not snug
Post by: Jim on September 11, 2013, 06:39 PM

I'll probably cut myself to ribbons but shall try cheers sid  :daumenhoch:

Title: Re: fork crown race not snug
Post by: Munnyella on September 11, 2013, 06:43 PM

If it fits ok, with no wobbles then you have no issues, if it slips a bit, do the can thing. I used to find that cheaper headsets were always a bit easier to fit the crown race on, but harder to get the cups in.

MM

Title: Re: fork crown race not snug
Post by: BENDYCAT ELEVENTEEN on September 12, 2013, 09:38 AM

yer there is a chance that the ring will just spin round the fork tube and dig in and cut it  :shocked:

Title: Re: fork crown race not snug
Post by: Bob_Acid on September 12, 2013, 11:28 AM

At least one of my bikes has a beer can shim on the fork race  :daumenhoch:

Title: Re: fork crown race not snug
Post by: Jim on September 12, 2013, 06:11 PM

All done no blood.....one snug race and one happy chappy  :slayer: