RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Munnyella on September 12, 2013, 07:37 AM
-
This question is asked quite a bit on here, most recently by me.
I have been and sourced some nuts for the `85 UK made plastic hubbed tuffs that were strewn all over MK this year.
the size is-
3/8" UNF 24 TPI.
if anyone has the `Definitive' sizes for other ones, older, newer, rear, coaster etc, please post them here, I will add them to the list and maybe a kindly MOD could add it to the T&R stickies list.
I could only get full nuts yesterday, but am trying to locate a box of flange nuts (hens teeth), which they would have had OG.
MM
-
Great idea :daumenhoch:
I know of a place that does those nuts but they are about £1.85 a pop. Have a cracking supplier on my computer at home will have a look when i get in :daumenhoch:
-
Nice one mark, I need four if these
-
Coaster hubs are 24tpi
New sealed are both with the 10 mile long axles 24tpi
-
I got some from this guy, not strictly OG but good nuts......
http://www.bmxnuts.co.uk/
-
I got some from this guy, not strictly OG but good nuts......
http://www.bmxnuts.co.uk/
Track nuts are always dear, 4 nuts cost the same as the 4 skyways I bought!!
I paid £2.50 for 24 hex nuts, they'll do for now!!
MM
-
I looked all over for a set of four for my Blue Tuff 2s with alloy hubs. Freewheel NOT coaster. My LBS told me to go to the hardware store.....thanks!
3/8 x 24TPI