RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: ED209 on December 05, 2013, 08:59 PM
-
trying to screw some crupi peds into Profile crank arms... they go on fine 'the wrong way round' ... so they unscrew when you pedal ... but they will not screw on the right way round ..... :idiot2: just won't screw into the threads ....
The profile are on the right sides... can't work it out :buck2:
-
Crank arms back to front? ???
-
Crank arms back to front? ???
nope - arm that screws onto the chainwheel is on the right.
so the pedals screw on the wrong sides so the logos on the pedals face the wrong way :teef:
-
Perhaps the pedal spindles were swapped over when they were run on a set of RHD cranks, used as left hand drive set up.
m
-
This /\ /\ /\ /\ was just typing it and pipped to the post
-
Perhaps the pedal spindles were swapped over when they were run on a set of RHD cranks, used as left hand drive set up.
m
cheers Mark ... you doing owt? :popcorn:
-
Perhaps the pedal spindles were swapped over when they were run on a set of RHD cranks, used as left hand drive set up.
m
cheers Mark ... you doing owt? :popcorn:
Drinking lager, ignoring twats on the telly.
-
think you nailed it there Marky lad - cheers bud :daumenhoch: