RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: factory pilot on December 30, 2013, 09:48 PM
-
Has anybody ever done this successfully ? I've got a black pair I want to remove and use again..is it possible ? how ?
..if not does anyone have a spare pair they don't mind selling ? ;)
cheers Ant :daumenhoch:
-
hair dryer?
warm them up and then a spray of wd40 perhaps
-
Cup full of boiling water, dunk the lever in, leave for 30 seconds and they should pop off a treat :daumenhoch:
-
Top stuff lads :4_17_5:..will try both(not at the same time ;)) :LolLolLolLol:
-
Cup full of boiling water, dunk the lever in, leave for 30 seconds and they should pop off a treat :daumenhoch:
+1, was the method I used all the time without fail bitd
-
Cheers again fellas... Off oop north for new year.. Will give it a go on my return!!!
-
Cheers again fellas... Off oop north for new year.. Will give it a go on my return!!!
I'm surprised you had to ask Ant ::)
I thought you were a Teacher??
Obviously not Physics then. :LolLolLolLol:
-
I teach 5 year olds... I only know about PVA glue and sick!!! Lol ;-)
-
Cup full of boiling water, dunk the lever in, leave for 30 seconds and they should pop off a treat :daumenhoch:
I do this to remove grips off handlebars
-
Just squeeze the WD40 straw inside, little squirt (they seem to get littler as you get older) and twist off.
-
About time we were treated to see Ant'a collection of Time Wharp HARO's... "help"