RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Bfellows on June 22, 2014, 08:51 PM
-
Any one have a link to a decent thread / tutorial on how to set up a 3 piece crank........ free wheel and chain ring are way off no matter which way I mount them (so to speak, obviously I'm not waving the old gentleman sausage at them.........)
Ta
Bert
-
Stands a chance its not the correct spindle ;)
-
Bang up some pictures of everything you have :daumenhoch:
-
Bang up some pictures of everything you have :daumenhoch:
except the gentleman sausage! "nono"
-
I used this.
http://www.danscomp.com/install/Poverty_POW_Three-Piece_Crank_Install.pdf
-
That's pretty good that :daumenhoch:
-
Bang up some pictures of everything you have :daumenhoch:
I'll take a few tomorrow as I've been sat in a beer garden most of the afternoon......... I have a sneaking suspicion I may have the spindle in back to front........ ;D
-
There is no back to front on a 3 piece as far as I know ;D
-
If it's a threaded conversion axle there is a right and wrong way, but it is pretty obvious which way is which or else you wouldn't be able to tighten it up.
-
True Nick, I always just think of new school when thinking of 3 piece cranks
-
There is no back to front on a 3 piece as far as I know ;D
I appear to have proved the rule that anything is possible if you try hard enough - put it in backwards............ ;D Nothing to see here, move along please.......... :nickswan: