RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: EDBANGER on July 18, 2014, 07:22 PM
-
I have some 1 inch Hoffman Super forks and a 1 inch Hoffman clamp on but it seems the clamp on is just fractionally too small so won't go onto the forks. It's seriously doing my head in now. Any ideas??
-
Been there done that Hoffman did two types of 1" early and late , the two types aren't interchangeable , spent ages trying to sort it don't bother.
I have a early nos 1" clamp hoffman stem that I can sell if it helps
-
PM'ing you bud...
-
If its the right size, I have had too on 1 1/18 stems take the bolts out and wind them in from the wrong side with a penny or a knife in the slot to make the opening slightly bigger. Slide the stem on and them put the bolts in the right way.
-
If its the right size, I have had too on 1 1/18 stems take the bolts out and wind them in from the wrong side with a penny or a knife in the slot to make the opening slightly bigger. Slide the stem on and them put the bolts in the right way.
Tried that one. Hammered a hard wooden wedge in to try and spread the gap a bit.
-
If its the right size, I have had too on 1 1/18 stems take the bolts out and wind them in from the wrong side with a penny or a knife in the slot to make the opening slightly bigger. Slide the stem on and them put the bolts in the right way.
Tried that one. Hammered a hard wooden wedge in to try and spread the gap a bit.
Hope you tried it from the bottom. :)
If in doubt, Get the angle grinder out >:D