RADBMX.CO.UK
BMX General => BMX Chat => Topic started by: Jt on September 25, 2014, 06:04 PM
-
What's the crack putting them on 24" new school tuffs.
Do they fit? Are they the same size? Etc
I have a black set I want to put silver ones on.
Thanks in advance
Jt
-
What's the crack putting them on 24" new school tuffs.
Do they fit? Are they the same size? Etc
I have a black set I want to put silver ones on.
Thanks in advance
Jt
I melted them down and created something less horrible instead
(http://safetythird.files.wordpress.com/2011/04/meltdown-chair_cable-tie-03sm.jpg)
Do you like it?
-
24's have more spokes so the flanges dont line up with the marks in between like on 20's. If you know what I mean?
-
Yup. Makes sense.
So anyone know where I can get some for 24"s?
-
There's a couple of people that make them maybe they could do you a bespoke set.
Bear in mind you really need to get covers for the bit of plastic hub that's left exposed too.
-
There's a couple of people that make them maybe they could do you a bespoke set.
Bear in mind you really need to get covers for the bit of plastic hub that's left exposed too.
Theres a bloke on facebook that makes the caps to cover the exposed plastic. I'll see if I can dig out a link to his page.
-
Didn't the originals have the plastic hubs anyway? i think the only difference is the originals would've been loose ball rather than sealed bearings ???
-
make sure you get ones that are specifically for 24in tuffs, theres a little plastic lip where it meets the gold hub on mine that stops the caps fitting flush, its only a couple of millimetres but enough for the cap to foul the cog on the rear....