RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: hokuspokus74 on November 07, 2014, 07:46 PM
-
Ive just noticed the cup on the hub is sticking out,i went to start to polish this and said fook how this happened,will it go in or how do i take it out,have any of you guys had to do anything like this?
(http://i854.photobucket.com/albums/ab107/hokuspokus74/IMAG0423_zpsb1421320.jpg) (http://s854.photobucket.com/user/hokuspokus74/media/IMAG0423_zpsb1421320.jpg.html)
-
I'm guessing from the question, it can't be tapped back in?
Is it a Shimano ?? If it is I think some of their hub variations have them like that for the plastic cone shaped grease seal to clip on :-\
-
For all you Airplane! fans
You can make a hat, a brooch, a pterodactyl :LolLolLolLol:
-
Yeah its a shimano Steve,so there should be a wee cap for it then?hmmm not sure were that would be.
-
Again I'm guessing you have a rear hub there?
You can see what I mean on the rear one in this pic....
(http://www.radbmx.co.uk/archive/albums/vv209/steve69-pics/null_zps432ba2b6.jpg)
:daumenhoch:
-
Cheers Steve I will have to have a look tomorrow for it,nice hubs,I was looking a nice set got ones of meticulousnice shimano ones :D