RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: Bfellows on November 29, 2014, 10:44 AM

Title: Skyway metal hub cup size?
Post by: Bfellows on November 29, 2014, 10:44 AM

Can anyone measure the cup bearing cup size of a rear metal hub skyway for me?  I need to check if a skyway rebuild kit would work on an OGK before I mod them for sealed bearings......

Ta
Bert

Title: Re: Skyway metal hub cup size?
Post by: Bfellows on November 30, 2014, 06:42 PM

Anyone hiding out the man cave.......  :tumbleweed:

Title: Re: Skyway metal hub cup size?
Post by: chubby on December 01, 2014, 10:35 PM

 "nono" them zytecs would have been alot less messing about our Bert  :LolLolLolLol:

Title: Re: Skyway metal hub cup size?
Post by: Bfellows on December 01, 2014, 10:39 PM

You might be getting a PM........  ;D I like a challenge though ;)

Title: Re: Skyway metal hub cup size?
Post by: Bfellows on December 10, 2014, 08:33 PM

Help...... Considering a peregrine sealed bearing conversion .....

Title: Re: Skyway metal hub cup size?
Post by: Bfellows on December 12, 2014, 06:26 PM

 :whistle:

Title: Re: Skyway metal hub cup size?
Post by: Bfellows on December 27, 2014, 12:25 PM

I'm going to end up buying one to measure at this rate....... Thumbs down

Title: Re: Skyway metal hub cup size?
Post by: john4130 on December 27, 2014, 03:10 PM

just measured mine but it still has the axle and dust seal on so it may not be exact but it looks like it's 30mm.

Title: Re: Skyway metal hub cup size?
Post by: Bfellows on December 27, 2014, 03:17 PM

Cheers fella  :daumenhoch: