RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Bananaman on January 24, 2007, 09:28 AM
-
Can I take the 9/16 spindles from my Victors and swop for the 1/2 inch in my XCII's????
I am sure this has been covered before, sorry :-[
-
i did
the only issue i had was the threaded end by the cap was a bit shorter than the suntour one
but was just about ok 90% of the nut engaged good enuff for me :daumenhoch:
sure a dab of thread lock would cure any problems
just need some end caps for them now, as the victor ones are slightly smaller diameter / thread - bastardo's :knuppel2:
-
Reminds me that I must restore the two pairs of XC-11's that I've got. I need t0 get some new cages though.