RADBMX.CO.UK
Old School BMX 1980 - 1988 => Old School Freestyle (frame stands and kickturns galore!) => Topic started by: rarman1 on July 16, 2007, 05:12 PM
-
hi fellas, i've got a pair of super pro 48 hubs,
what are your recommends as far as rims go, i would think that peregrine 48 rims are rare/hard to get,
cheers ;)
-
peregrine hp
camacura fd pro high wall rims tad heavy
araya super 7x
sun rims
-
araya super 7x
" himiko
ukai 48's
sun bfr
" rhyno lite
" big city
primo hula hoops(might be pushing it a bit but they sold at the same time so....)
-
i've got a pair of araya 7x's but their laced to hubs already(not sure what the hubs are though)
and i have a pair of primo hula hoops too, but the hula's chrome is badly flaking and its got a couple of paches worn through on the sides,
is it worth having them rechromed or not ?
-
i get the odd set rechromed as alot of rims are hard to find .
some are easy to find just got to look in the right places
ukai speedlines are an early peregrine rim.
-
do you have an idea of the cost of rechroming a pair of rims would be ?
do the speedline's look the same as the hp rims ?
-
i get loads of stuff done at the same time but wuld guess at £15/20 per rim only guessing
speedlines are usualy ano finish but are the first gen type peregrine and look the same
but i have seen a set that look more like araya 7x.
-
i like these if you can get hold of them sunn rims ,some dont like but they are a nice rim.
(http://)(http://www.radbmx.co.uk/archive/albums/d87/harris15570/100_0616.jpg)
-
cool thanks dan, dsd, i'm gonna sit down and ponder on this for a bit, lol
completely of subject but i have a seat post stuck right downfrom the top to the bb on my 84 performer (i know unbelivable),
is the only option to have it drilled out !!
thanks,
yeah i like those, what size spokes o you use dan i.e what g (i think)
-
just regular as most are ,not the big fat gack 14g
-
cheers dan :daumenhoch:
-
alans were selling super 7x's last time i looked.
ive got hula hoops that the chrome is flaking on and the rims have been dry stored and never used.
-
Dan
Unless that is come kind of hub guard ... youve got your king cone on upside down! The wide part meats the dropouts, the pointy side on the bearing.
-
i just put them on alex as they fell ooof ;)
-
Yeah, I know what you mean Dan, They just flap about on there till the frame holds them in place
-
king axles are they ment to be fully floating a mine are ???
-
The axle should be held tight between the bearings. The cones just sit there, and fall off when you tip the wheel. They just tighten up with the wheel nut. Its the best way as there is no chance of the cone coming loose underneath a tight wheelnut. It might be better if they were push fit over a threadless part of the axle .... but they aint!
-
alans were selling super 7x's last time i looked.
ive got hula hoops that the chrome is flaking on and the rims have been dry stored and never used.
yeah i had a look on alans they look the same as big city rims which are 4 quid cheaper, but are big city's better than 7x's
the chrome must be a poor job on hula's then as mine look awfull :LolLolLolLol: