RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: harris on October 24, 2007, 03:20 PM
-
i just built up a rear coaster hub suntour jobby
well the rear sprocket seems a bit sloppy not front to back but side to side as in it jiggles like its not the correct size.
has anyone got one to hand to see if its tight as i might have it not correctly assembled.
-
Dan,if you have original sprocket and clip,they tend to be nice and tight with no play ,but you can get other sprockets and clips that fit fine other than they have play in which tends to be from side to side.I'm not sure if this will cause damage in the long run though ,as i've never used one for riding.Hope this is what you mean .......
-
yep jay its of a different coaster sprocket and clip unknown brand so will have to looky out for an original :4_17_5:
i just fitted a rubber o ring gasket on and then the clip and its tight now.