RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: funkwit on October 25, 2007, 12:22 PM
-
I am trying to install a Profile euro BB into my CW mini frame, but I can't seem to get the cups to screw in. One of the cups has a little groove etched into the lip, and I'm assuming that this marks it as the drive-side cup. Can anyone confirm that this is the correct assumption? If it is the correct cup for the drive-side, what direction should I be trying to screw the cup - clockwise or anti-clockwise? I've heard that the drive-side uses a left-handed thread but I'm not sure what that means in terms of the direction the cup should be screwed. Or the direction that the non drive-side should be screwed for that matter. Can anyone help me? Please....
Thanks
Marc
-
I think you'll find that the drive side screws in clockwise so that when your pedalling its not going to come loose,
the other if ya looking at it goes anti-clockwise so when you look at it both threaded cups are turning towards the
front wheel, this is with the bike on its wheels.
Correct me if im wrong
-
Thats how I remember it. Both cups tighten up, by screwing towards the front of the bike (when the bike is the right way up).
(But its been a few years since i did a euro BB so that might be the other way round)
-
Cool, thanks guys!
-
Also don't force it if they dont just run in nice ans smooth. I know on the mrd mini I had to get the threads run through again at a local bike shop as the original threads whilst NOS weren't quite clean enough!!