RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: se-bmxer on October 28, 2007, 08:03 PM

Title: de-anodising profile stems
Post by: se-bmxer on October 28, 2007, 08:03 PM

Anyone de-anodised a profile stem, i've got a black one and need it silver
just need to know if the oven pride stuff works on these stems  :daumenhoch:

Title: Re: de-anodising profile stems
Post by: Dingobmxer on October 28, 2007, 08:10 PM

is it a clamp on one Jai?

 :) DINGO :)

Title: Re: de-anodising profile stems
Post by: se-bmxer on October 28, 2007, 08:15 PM

Quote from: Dingobmxer on October 28, 2007, 08:10 PM

is it a clamp on one Jai?

 :) DINGO :)

certainly is Mark, new jobby

Title: Re: de-anodising profile stems
Post by: Dingobmxer on October 28, 2007, 08:25 PM

it will work mate, I did a Profile black chainring

chuck it in oven pride, wait until it turns grey, take out and rinse off then wear your fingertips out sanding and polishing the fooker  :LolLolLolLol:

 :) DINGO :)

Title: Re: de-anodising profile stems
Post by: se-bmxer on October 28, 2007, 08:28 PM

Quote from: Dingobmxer on October 28, 2007, 08:25 PM

it will work mate, I did a Profile black chainring

chuck it in oven pride, wait until it turns grey, take out and rinse off then wear your fingertips out sanding and polishing the fooker  :LolLolLolLol:

 :) DINGO :)

cheers m8, i'll give it ago got to get cheaper than buying a new one

Title: Re: de-anodising profile stems
Post by: Dingobmxer on October 28, 2007, 08:31 PM

and it gives you a real sense of satisfaction doing it  :daumenhoch:


 :) DINGO :)