RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Gary72 on December 12, 2007, 11:10 AM
-
Stripped some hubs the other day to clean and re-grease only to find hub cones pitted. No problem got some new ones.
Went to finish the job last night and found that on the rear 1 side is smaller than the other and even the ball bearings are smaller inside :wtf:
Anyone else had this?????????
Also can anyone tell me what the thread size is on the axles as I would like to run a thread cleaner/cutter down it.