RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: kuwahero on December 17, 2007, 12:28 PM
-
Hey Guys
I purchased some Suntour VX cranks from the evil bay, which I was going to restore. However, >:( I have been shafted and the non drive arm is twisted. Its about 10-15 degrees out of line as the square taper hole is deformed.
Is there any way I can get this repaired or has anyone got a spare single crank arm.
Any help would be appreciated
Marc
-
ive got same problem too with set cranks if anyone can all weld/repair em id like to know too please
-
Top Up
-
If you can't get a replacement arm, then I reckon an engineering shop could machine the square hole true again and fabricate some sort of shim to take the gap up.