RADBMX.CO.UK
BMX General => BMX Chat => Topic started by: Flatcap on December 22, 2007, 09:46 AM
-
I'm not sure if this is a daft question or not.....I've got some very early Kneesavers I want to use on a build but like a d1ck I cut them down years ago, seamed like a good idea at the time ::)
Is it possible to get some bar extenders like "bar ends" that would fit inside the end of the bars but extend by about an inch or so and then once the grips were fitted you wouldn't be able to tell.
I've googled it but came up with nowt, probably searching under the wrong title/name.
Is there such a thing?
Thanks in advance.
Daz. :daumenhoch:
-
Daz if you are not in a rush i can probably sort them out for you in the new year. :daumenhoch:
-
Daz if you are not in a rush i can probably sort them out for you in the new year. :daumenhoch:
Ok mate....how would you do it?
You gonna weld a piece on?
I know I can get some bar ends like they use on big motorbikes that extend by an inch or so but I'm not sure they're the right diameter.
Daz. :daumenhoch:
-
Daz if you are not in a rush i can probably sort them out for you in the new year. :daumenhoch:
Ok mate....how would you do it?
You gonna weld a piece on?
I know I can get some bar ends like they use on big motorbikes that extend by an inch or so but I'm not sure they're the right diameter.
Daz. :daumenhoch:
i've had a look but can't find them neither, there was a discussion about them before and i think s&m alex said he had used them.
-
i just weld bits back on ,ive done about 8 sets now for members and are spot on.
-
I made some ally bar ends to extend a set of bars that I cut down too much. They were great cos they were solid so you didnt need to put normal bar ends in um after.
-
i just weld bits back on ,ive done about 8 sets now for members and are spot on.
just like Harris said ::) ::) ::) ::) ::) ::)
-
i just weld bits back on ,ive done about 8 sets now for members and are spot on.
just like Harris said ::) ::) ::) ::) ::) ::)
Ok mate - cool!
Daz.