RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: BigG on December 29, 2007, 01:05 PM

Title: Profile Cranks
Post by: BigG on December 29, 2007, 01:05 PM

Help!

I want to buy a Profile Race Crank for my Haro Group 1 RS1 Frame.  First question is will it fit?  If so, do I go for American BB's if they are American frames??  I'm looking at Alan's as they appear to be the cheapest, does anyone know of anywhere cheaper???

 :-\  :-\  :-\

Title: Re: Profile Cranks
Post by: harris on December 29, 2007, 01:10 PM

yes they will fit with us .american bb  you might not be able to run a very small sprocket  ie
anything lower than a 39t 

Title: Re: Profile Cranks
Post by: rarman1 on December 29, 2007, 11:29 PM

i got mine from here,

http://cgi.ebay.co.uk/Cranks-Profile-3-Piece-BMX-hop-ti-175mm-race-bike-ch_W0QQitemZ260166971757QQihZ016QQcategoryZ48843QQcmdZViewItem

when i collected them from the post office i had to pay £19 vat on top, but the saving is massive as compared to the uk prices and the shipping was good from the usa around 2 weeks,

the cost of the ti spindle and hop up kit in the uk alone is £115 you get - ti spindle + hop up + cranks for £113 from there, all in i paid 150 inc the uk vat.

 ;)

Title: Re: Profile Cranks
Post by: Trev on December 29, 2007, 11:40 PM

I can do you a Ti-Axle for Profile cranks for £65 posted.

Title: Re: Profile Cranks
Post by: BigG on December 30, 2007, 09:53 PM

Thanks for the advice guys

 :daumenhoch: