RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: Moose on February 12, 2008, 03:01 PM

Title: Bars id
Post by: Moose on February 12, 2008, 03:01 PM

Anyone know? They look pretty good quality - 25" wide, 8" rise?

(http://www.radbmx.co.uk/archive/albums/e250/Christmoose/Misc/P1010380.jpg)

Title: Re: Bars id
Post by: pickle on February 12, 2008, 03:03 PM

WIN Bars??  i'm rubbish at this type of thang  :(

Title: Re: Bars id
Post by: munners on February 12, 2008, 03:04 PM

hUTCH?

Title: Re: Bars id
Post by: diesel on February 12, 2008, 03:07 PM

Burner ? - they slope back like them

Title: Re: Bars id
Post by: pickle on February 12, 2008, 03:10 PM

these are my WIN Bars (that i just happen to have at work)  :daumenhoch:

(http://www.radbmx.co.uk/archive/albums/b339/robertbransby/winbars.jpg)

Title: Re: Bars id
Post by: Moose on February 12, 2008, 03:16 PM

They do have a fair bit of sweep and I suspected they were burner bars, but they seem like quite good quality and don't weigh a ton either?

I think you're right - I actually bought a burner once  :-[  and have compared picture of the bars and they look pretty similar.

Embarassed now that I said they looked pretty good quality  :-[ :LolLolLolLol:

Edit: those win bars look similar also - did win make the bars for raleigh?

Title: Re: Bars id
Post by: pickle on February 12, 2008, 03:18 PM

i'd say they look too good for Burner bars?!?  the WIN bars i've posted up do have a fair bit of sweep to them as well.

and the same gnarly bits for the stem clamp