RADBMX.CO.UK
BMX General => BMX Chat => Topic started by: moley on February 18, 2008, 10:02 PM
-
I purchased a OS Dyno Helmet off ebay a while back.
It's okay apart from the thin spongy fabric liner was super sweaty. I removed the polystyrene protection from the helmet so I could get the fabric out and give it a good wash.
The fabric looked like it had been taken off before because it was just taped back on with some brown packing tape.
The fabric is a bit worse for wear and 2 Sponge pads from around the ears had totally disintergrated.
Does anyone know where I can get a new piece of fabric from?
Has anybody had a go a replacing these parts?
It was an impulse buy. Sometimes I just can't resist.
If I can get some spongy thin fabric and I'll stick some spongy bits for the ears, it would look alright.
Any suggestions?