RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: adam68 on August 21, 2008, 07:41 PM
-
Can anyone help. The breakes on my skyway street beat are crap!!! :-[
There diacomp MX with repro tuff pads on tuff 2s.
They seam to be set up ok.
Is there any better breaks i can use or any other pads anyone has tryed??????????
Cheers Adam
-
Try some light sandpaper on the tuf pads to wear them down a bit, and re-check everything again. Should be ok? ??? :)
-
Too true :LolLolLolLol:
Old school brakes were never that good! just we were all 5 stone lighter in the 80's ;D ;D
Bru :daumenhoch:
-
Nearer 9 stone lighter ;D
-
28 years and ive still not managed to find brakes that stop me, perhaps a coaster brake for ya skyways fella :LolLolLolLol:
-
Maybe not quite 9 stone but was a lot smaller then.
Coaster break???
-
Coaster break???
As in a pedal back brake, you can normally find em on the bay.
-
I have just put some on my Quad Freestyler!!
I tried to fit an ACS Freecoaster device to it but ot doesn't fit the New School Tuffs!!
I will test ride it tomorrow!!
Knowing my luck, I'm expecting to fly over the handlebars at some point!! :buck2:
-
I'm not hitting the ramps with it!! :shocked:
Just for Back hops and practice some kick turns.
If I go over the bars once then I'm ditching it!! :daumenhoch:
-
Ive seen them on the bay too, but maybe i wont try one of those then!!!!!!!
I can remember the last time i hit concrete with head, not one of my best past times! :-\
-
foot jams works wonders on tuffs lol
try some new stickier pads
-
Foot jams at my age lol ;D
Will try new pads though
Cheers