RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Thejackal on June 01, 2009, 09:43 PM
-
A daft question, and one that will have been asked dozens of times over the past, but
can you fit a Redline (or similar) chainring to a one piece crank?
Many thanks :daumenhoch:
-
yes
-
+1 , if its 22mm center (most 3pc) you can reame it out to 24mm, reamer bit from diy shop 3quid or so fits in battery drill, alloy cr cut real easy, takes about 5 min :daumenhoch:
-
Thanks Bigfrawg and Oldtired.
Wanted the opinion of more knowledgeable RADsters than myself before I took the crank out.
Cheers guys :daumenhoch:
-
HOLD THAT! sorry J 23.4MM, carefull or you'll end up with a baggy ring, im sure you dont want that ;)
-
carefull or you'll end up with a baggy ring, im sure you dont want that ;)
Isn't that what some girls from Budapest have on theose dodgy websites I get, erm, told about... :2funny:
-
+1 , if its 22mm center (most 3pc) you can reame it out to 24mm, reamer bit from diy shop 3quid or so fits in battery drill, alloy cr cut real easy, takes about 5 min :daumenhoch:
Wouldnt really recomend reaming it by hand!
-
done a few as long as your carefull it works ok,