RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: endo on June 18, 2009, 08:28 PM

Title: odysey brakes
Post by: endo on June 18, 2009, 08:28 PM

hi guys


got an odyessy evo 2 brake but can't work out how to set it up any one got any tips for me

cheers endo

Title: Re: odysey brakes
Post by: subversion on June 18, 2009, 09:00 PM

Put the arms on the lugs without the springs on & get your pads dialed first. Remove the arms & put your springs on & install the arms again. Note that spring orientation should make the arm resist when you twist the the brake pad towards the rim (it should flick open when you let the arm go). You achieve this by using a spanner to tension the spring & then tighten down the brake bolt into the frames lug. Install your chosen cables & then use the same method to 'centre' the brake pull on both sides (don't make the springs too tight or they will fail)

good luck mate :daumenhoch:

Title: Re: odysey brakes
Post by: endo on June 18, 2009, 10:33 PM

cheers mate will give it a try and let you know how i get on

Title: Re: odysey brakes
Post by: endo on June 21, 2009, 06:15 PM

sorted thanks for the advice buddy

Title: Re: odysey brakes
Post by: tobybrown35 on June 21, 2009, 09:04 PM

just saved me from startin a new topic does same apply 2 oddysey a brake :daumenhoch:

Title: Re: odysey brakes
Post by: subversion on June 21, 2009, 11:23 PM

Quote from: endo on June 21, 2009, 06:15 PM

sorted thanks for the advice buddy

welcome dude :daumenhoch: