RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: oldschoolib on October 13, 2009, 08:58 PM

Title: best way to apply new stickers to refurbed frames
Post by: oldschoolib on October 13, 2009, 08:58 PM

looking for info on best way to apply stickers to restored frame heard of loads of ways water, hair dryer ? looking to get best info i can

Title: Re: best way to apply new stickers to refurbed frames
Post by: CD17 on October 13, 2009, 09:01 PM

http://www.radbmx.co.uk/forum/index.php'topic=24584.0


 8)

Title: Re: best way to apply new stickers to refurbed frames
Post by: sweetbeats on October 13, 2009, 10:15 PM

I recommend a good hammer to make sure they are stuck on properly  :daumenhoch:

Title: Re: best way to apply new stickers to refurbed frames
Post by: NORTY40 on October 13, 2009, 10:30 PM

Quote from: sweetbeats™ on October 13, 2009, 10:15 PM

I recommend a good hammer to make sure they are stuck on properly  :daumenhoch:

 :LolLolLolLol:  :2funny:

Title: Re: best way to apply new stickers to refurbed frames
Post by: steve Beech TA on October 13, 2009, 11:03 PM

It also helps to use a spray bottle with a week solution of washing up liquid and water spray on and apply decal and slide to the right position and smooth out air bubbles. a piece of masking tape can help to get the decal st rate, using it as a strait edge.

to finish of use the hammer as sated above, this is good for air bubbles  ;D ;D

hope this helps

steve  :daumenhoch: