RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: HUTCHMAN on November 04, 2009, 06:09 PM

Title: straigh stay ripper
Post by: HUTCHMAN on November 04, 2009, 06:09 PM

Can anyone do(or has got) a side on pic(real close up) of the very rear end of a straight stay/curved stay ripper.i need to see the datail of the two notches.the r/h dropout has been ground away by a badly fitted wheel,but the welder took it upon himself to put some weld over the notches on the l/h dropout.now i've got no reference point to refinish the other side.also could the distance between the notches be measured,i should imagine it's 10mm.any help appreciated.

Dave.

Title: Re: straigh stay ripper
Post by: HUTCHMAN on November 04, 2009, 06:52 PM

thanks bubby,your a star.  :daumenhoch:

Title: Re: straigh stay ripper
Post by: moley on November 04, 2009, 07:03 PM

The Notches are 5mm wide and the gap between the top notch and the bottom notch is around 10mm (which amazingly, is the size of an axle!!!)  :D

I used a plastic crappy ruler so the measurements are approx!!

Title: Re: straigh stay ripper
Post by: HUTCHMAN on November 04, 2009, 07:25 PM

cheers Moley,it all helps.