RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: Peter J on November 11, 2009, 11:58 AM

Title: Removal of bearings and cups
Post by: Peter J on November 11, 2009, 11:58 AM

Does anyone have a solution (other than BIG HAMMER) to removing bearings and cups (Redline twin pinch).

I've sold an F&F and wanted to remove them


or


Is it just easier to leave em in and pass on a bit of BMX love  :daumenhoch:

Title: Re: Removal of bearings and cups
Post by: pickle on November 11, 2009, 12:20 PM

what i do is use an extension bar from a socket set, put it through and against the cup (inside) then tap away with a hammer....works a treat  :daumenhoch:

or leave em in and spread the luurve  :daumenhoch:

Title: Re: Removal of bearings and cups
Post by: Peter J on November 11, 2009, 12:24 PM

Sorted did the socket bar + Tape over the end.........

The trick is


12

6

3

9

 :daumenhoch: