RADBMX.CO.UK
Technical & Reference Section => Tech and Restoration => Topic started by: Hedsta on November 29, 2019, 09:24 PM
-
Evening chaps...
Im sure this has been covered before whats the best advice re-attaching the rivet that holds the quick release in place on an MX-900?
I know I can get the replacement studs but its the putting them back o that Im stuck with. I've read you need a press and I've read you can do it with a hammer?
Any advice on what size replacement studs I'd need as well would be gratefully received as I've never done this before :uglystupid2: :uglystupid2:
Thanks in advance as always
Steve
-
You need a rivet press bud, you'll never do it with a hammer. I'm sure Steve "Animal" made a jig to do them but don't know if he's still got it - would be worth dropping him a pm to see :coolsmiley:
-
Thanks bro...wil look him up.
You dont know what size rivets I'd need? I can find them for MX1000's but not sure if the same ones would fit 900's?
Thanks again
Steve :) :)
-
You can do this quite easily with a a rivet snap and hammer. Rivet snaps are cheap:
https://www.ebay.co.uk/itm/Rivet-Snaps-UK-Made-Model-engineering-live-steam-model-loco-traction-engine/330703010063?hash=item4cff6f790f:m:m-5NfQcABYmWIAK0AA8o0UQ
They are simply punches with a concave dimple in the end. From memory I think I used 3/32
-
Thats really helpful mate..
Ive ordered one and Ive got a few spare rivets comming so fingers crossed
fistblump fistblump