RADBMX.CO.UK

Technical & Reference Section => Tech and Restoration => Topic started by: harris on July 18, 2007, 08:23 PM

Title: decals and ovens info need
Post by: harris on July 18, 2007, 08:23 PM

has anyone got away with leaving on a decal whilst in oven  after touch up repainting.
this is the prob i just tonight noticed a tiny crack on my raceinc cruiser on the seatpost tube
its been finished so decaled up.i want to clean and spot the crack before she runs and repaint area
can i cover other decals in a low baked oven or just remove  ????

Title: Re: decals and ovens info need
Post by: sawzall on July 18, 2007, 08:39 PM

danny if the decals are not that close to damage you should be able to keep blow in small enough not to affect decals just a bit of careful masing and back taping ,the heat from the oven wont affect decals but if you are worried about baking let it air dry over night :daumenhoch:

Title: Re: decals and ovens info need
Post by: harris on July 18, 2007, 08:41 PM

they are a fair way from seat tube so not to bad,just wondered if anyone had done it before.
or i can just order a new set.

Title: Re: decals and ovens info need
Post by: sawzall on July 18, 2007, 09:43 PM

worth a go before you get a new set of decals ;)

Title: Re: decals and ovens info need
Post by: sonic-1 on July 19, 2007, 10:25 AM

just get diffrent hardener for the paint they do an air dry one or they used to