Author Topic: Removeable giro tab holes in frames (Read 1733 times)

oldtired · « **on:** September 27, 2011, 11:35 PM »

are they all set at the same hight on new schoolie frames? if so? any chance of one of you bunging up the measurment from top of the headtube to center of top hole/mounting position?

Cheers

fugazi · « **Reply #1 on:** September 28, 2011, 09:15 AM »

Are You going to use the usual generic type or the Fly Guiri tabs?

oldtired · « **Reply #2 on:** September 28, 2011, 10:38 AM »

hadn't decided as yet which is one of the reasons i was asking as i know they are different , although it looks like its only aboout 5mm diference between the two sets of tabs, quit like the look of the fly ones with the thread in the middle instead of the generic L shape tab , i assume you've got new schoolie frame , measurements would be cool for which ever tabs you use

fugazi · « **Reply #3 on:** September 28, 2011, 01:37 PM »

I've got both types here, I'll measure them & get back to You

oldtired · « **Reply #4 on:** September 28, 2011, 03:28 PM »

nice one

do you think drilling holes in a frame voids your warranty then ?

fugazi · « **Reply #5 on:** September 28, 2011, 04:02 PM »

Personally I don't think it should if it's done well, but most bike co's will say it does! Here's the measurements from Two frames I have

Frame with Fly tabs 15mm to centre of top threaded hole.
Frame with normal tabs 22mm to centre of peg hole.

oldtired · « **Reply #6 on:** September 28, 2011, 04:51 PM »

cheers for that

figured it was about 5mm difference so with it being 7mm wouldn't of been that far out , right, a little bit of fiddling then

fugazi · « **Reply #7 on:** September 29, 2011, 09:38 AM »

I'd think You could go a few mm either side of those measurements with no problems anyway, main thing is to get them level both sides

JAY · « **Reply #8 on:** November 11, 2011, 10:28 PM »

Does anyone know the thread size for the Giro tabs

Peter J · « **Reply #9 on:** November 11, 2011, 10:36 PM »

http://www.bmx-u.com/index.php'title=Adding_Gyro_Tabs

JAY · « **Reply #10 on:** November 13, 2011, 10:54 PM »

Perfect, Cheers mate

Author Topic: Removeable giro tab holes in frames (Read 1733 times)

oldtired

Removeable giro tab holes in frames

fugazi

Re: Removeable giro tab holes in frames

oldtired

Re: Removeable giro tab holes in frames

fugazi

Re: Removeable giro tab holes in frames

oldtired

Re: Removeable giro tab holes in frames

fugazi

Re: Removeable giro tab holes in frames

oldtired

Re: Removeable giro tab holes in frames

fugazi

Re: Removeable giro tab holes in frames

JAY

Re: Removeable giro tab holes in frames

Peter J

Re: Removeable giro tab holes in frames

JAY

Re: Removeable giro tab holes in frames