Old School BMX 1980 - 1988 > Old School Freestyle (frame stands and kickturns galore!)

1984 Mike Dominguez Oldest Haro Gen 1 Sport now Finished

<< < (12/23) > >>

Retrodan72:
Loving this thread mate, it's a lot more than just buying parts and slapping them on. Top work.  :4_17_5:

Ady:
Right then..
Time to build this puppy.. fistblump

The final part arrived the pad set from Steve (Cracking job mate)..
Here is a pic of the parts to complete this build..
I have stripped and refurbish most of the bits and now the best bit ... :coolsmiley:

assembly . :slayer:







Well.
made a start today fitting the tioga beartap 11 headset and suntour headlock..
To be honest I was having a nightmare fitting the bottom bearing shell which fits onto the forks..
It just would not fit.
I heated the part and again it just would not fit..
In the end I took the part of a set of Haro master forks and tried that.
At first it would not fit as I needed something solid to fit over the forks threads but wide enough to fit the bearing shell..
I the end had a brainwave (A first for me  ::) ) I took one of the supporting legs of my bike building stand and a rubber mallet and a few taps it was in..
then called it a day.. :daumenhoch:

deeman:
Really looking forward to this Ady! 3 seatclamps is a bit overkill....one should be sufficient!!!  :LolLolLolLol:

Ady:

--- Quote from: deeman on May 15, 2016, 04:06 PM ---Really looking forward to this Ady! 3 seatclamps is a bit overkill....one should be sufficient!!!  :LolLolLolLol:

--- End quote ---

 :LolLolLolLol:

Well..
One I bought cheap which was damaged due to someone over-tightening and just needed the bolt..
The second I bought was a bit faded and wasn't happy with.. ::)
The third is the one I used which needed a bolt..

factory pilot:
It's gonna look brilliant ... Great attention to detail will make this build very special :daumenhoch:

Navigation

[0] Message Index

[#] Next page

[*] Previous page