Old School BMX 1980 - 1988 > Old School Freestyle (frame stands and kickturns galore!)

Parts ID on the Craig Campbell Prolite

<< < (5/6) > >>

deeman:

--- Quote from: dancetothedrummersbeat on October 23, 2016, 09:36 PM ---Based on the above I therefore stand corrected. The lower part of the stem is white - did suntours some in white? Unless it was painted post production?   :-\

--- End quote ---

I am not so sure now Andy. In the pic the stem appears to have about an inch of material between the flat bottom of the stem and where it meets the shaft, The Suntour only appears to have about a 1/4 inch...same as the Skyway. I also reckon it's the lighting in the pic which is making the bottom half appear white, I reckon it's a raw stem. Perhaps Nick is correct.... :-\

brettypeeps:


I am sure it is not a skyway.  it is far to curved

steve69:

--- Quote from: brettypeeps on October 23, 2016, 09:35 PM ---
--- Quote from: brettypeeps on October 22, 2016, 08:20 PM ---Just been looking at the stem and fairly certain it is a Suntour. I hope so as I have fitted it




Sent from my iPhone using Tapatalk

--- End quote ---

[ Attachment: You are not allowed to view attachments ]

--- End quote ---
As you can see in the two pics here, the section at the bottom of the stem where the main shaft is attached is much bigger than the Suntour

The ACS stem's proportions are more likely.

steve69:
Also the way the stem pad sits, as it would on the underside support web of ACS stem  ;)

That Swan Guy:
they were bomb proof too

Navigation

[0] Message Index

[#] Next page

[*] Previous page