Technical & Reference Section > Tech and Restoration

removing profile cranks

<< < (2/4) > >>

THIRSTYKIRSTY:
rob

if ya get stuck mate

give me a shout ,,,will do it for ya

rus

boofy44:
think the weekend had caught up with me.after screaming the street down i realised what i should be doing.can't
get the fooking bearings and cups out now.dont want to bray them out coz i'm selling them. :wtf:

pickle:
i always use the screwdriver method......put it through and against the insode edge of the bearing cup, then tap gently going round and it should pop out  :daumenhoch:

moley:
I use an extension bar off a socket set.

The nice square but rounded end is perfect for sitting against the bearing cup and smacking it out.

Makesure you grease the BB and new bearing cup to aid installation and removal in the future!!  :daumenhoch:

boofy44:
i soaked them overnight in wd40 and managed to get them out using the screwdriver method.
cheers fellas.

Navigation

[0] Message Index

[#] Next page

[*] Previous page